d7/d2f/gconfig_2SetCuts_8C_source.html

void SetCuts()

{

  //@@@cout << "SetCuts Macro: Setting Processes.." <<endl; //exit(0);


  // ------>>>> IMPORTANT!!!!

  // For a correct comparison between GEANE and MC (pull distributions)

  // or for a simulation without the generation of secondary particles:

  // 1. set LOSS = 2, DRAY = 0, BREM = 1

  // 2. set the following cut values: CUTGAM, CUTELE, CUTNEU, CUTHAD, CUTMUO = 1 MeV or less

  //                                  BCUTE, BCUTM, DCUTE, DCUTM, PPCUTM = 10 TeV

  // (For an explanation of the chosen values, please refer to the GEANT User's Guide

  // or to message #5362 in the PandaRoot Forum >> Monte Carlo Engines >> g3Config.C thread)

  //

  // The default settings refer to a complete simulation which generates and follows also the secondary particles.


  gMC->SetProcess("PAIR",1);

  gMC->SetProcess("COMP",1);

  gMC->SetProcess("PHOT",1);

  gMC->SetProcess("PFIS",0);

  gMC->SetProcess("DRAY",0);

  gMC->SetProcess("ANNI",1);

  gMC->SetProcess("BREM",1);

  gMC->SetProcess("HADR",1);

  gMC->SetProcess("MUNU",1);

  gMC->SetProcess("DCAY",1);

  gMC->SetProcess("LOSS",2);

  gMC->SetProcess("MULS",1);

  //gMC->SetProcess("STRA",1);


  // -> think! Double_t cut1 = 1.0E-3;         // GeV --> 1 MeV

  Double_t cut1 = 1.0E-3;         // GeV --> 1 MeV

  Double_t cutb = 1.0E4;          // GeV --> 10 TeV

  Double_t tofmax = 1.E10;        // seconds

  //@@@cout << "SetCuts Macro: Setting cuts.." <<endl;


  gMC->SetCut("CUTGAM",cut1);

  gMC->SetCut("CUTELE",cut1);

  gMC->SetCut("CUTNEU",cut1);

  gMC->SetCut("CUTHAD",cut1);

  gMC->SetCut("CUTMUO",cut1);

  gMC->SetCut("BCUTE",cut1);

  gMC->SetCut("BCUTM",cut1);

  gMC->SetCut("DCUTE",cut1);

  gMC->SetCut("DCUTM",cut1);

  gMC->SetCut("PPCUTM",cut1);

  gMC->SetCut("TOFMAX",tofmax);

}